Whistler Scanners

Cheap scanner that will decode Digi Modes, you’re going to need these, the whistler range will throw an error or two your way…… cheat sheet below!

Software for the TRX-1 and WS1088 with WS1095 drivers are here for convenience, however I recommend downloading direct from whistler, I do not accept responsibility for any software: TRX-1Install_3.1.0.481   or    WS1080Install_2.17.0.460    or    WS1095-Scanner-Drivers (1)

01-00 General heap error Contact Support and provide error code information
01-01 Unable to allocate from help Contact Supprot and provide error code information
02-00 Unknown object type in data Use PC Application to delete any corrupted objects or create a new configuration
02-01 Unknown TSYS type in data Use PC Application to delete any corrupted TSYS objects or create a new configuration
03-00 No MicroSD card inserted Ensure that a properly formatted MicroSD card is fully inserted and locked in the MicroSD slot.
03-01 General error initalizing file system Reinsert the SD card to ensure it is fully inserted in locked in the SD card slot. If necessary, reformat the SD card using the PC Application “Prepare SD Card for use” option. Replace the SD card if the problem persists.
03-02 Cluster size bad Reinsert the MicroSD card to ensure it is fully inserted in locked in the MicroSD slot. If necessary, reformat the MicroSD card using the PC Application “Prepare MircoSD Card for use” option. Replace the MicroSD card if the problem persists.
03-03 Error reading SD card Reinsert the MicroSD card to ensure it is fully inserted in locked in the MicroSD slot. If necessary, reformat the MicroSD card using the PC Application “Prepare SD card for use” option. Replace the MicroSD card if the problem persists.
03-04 Error writing SD card Reinsert the MicroSD card to ensure it is fully inserted in locked in the MicroSD slot. If necessary, reformat the MicroSD card using the PC Application “Prepare SD card for use” option. Replace the MicroSD card if the problem persists.
03-05 MicroSD card is full Reduce size of configuration, remove unnecessary audio recordings or switch to a MicroSD card with more capacity.
03-06 MicroSD card write protected Reinsert the MicroSD card to ensure it is fully inserted in locked in the MicroSD slot. If necessary, reformat the MicroSD card using the PC Application “Prepare SD card for use” option. Replace the MicroSD card if the problem persists.
03-07 Mass storage mode is active Under normal conditions this error should not appear. Mass storage device mode is disabled when the scanner is connected to a computer and scanning. Disconnect the radio from the computer, wait a few seconds, then reconnect. Contact Support if the problem persists.
03-08 Unknown MicroSD card read/write error Reinsert the MircoSD card to ensure it is fully inserted in locked in the MicroSD slot. If necessary, reformat the MicroSD card using the PC Application “Prepare SD Card for use” option. Replace the MicroSD card if the problem persists.
04-00 Initialization error Contact Support and provide error code information
04-01 Initialization error Contact Support and provide error code information
04-02 Firmware load error Contact Support and provide error code information
05-00 Unable to load CONFIG_.BIN Reformat the SD card using the PC Application “Prepare SD Card for use” option. Replace the SD card if the problem persists.
05-01 CONFIG_.BIN file error Reformat the SD card using the PC Application “Prepare SD Card for use” option. Replace the SD card if the problem persists.
05-02 CONFIG_.BIN file error Reformat the SD card using the PC Application “Prepare SD Card for use” option. Replace the SD card if the problem persists.
05-03 CONFIG_.BIN file error Reformat the SD card using the PC Application “Prepare SD Card for use” option. Replace the SD card if the problem persists.